CANAM STANDARD REBUILD PARTS

Important: The photo is a generic representation of a complete kit. You will receive the correct kit based on the machine information you provide. Add your year, make, and model in the order notes.Fitment: Can-Am Gen 2 1000cc ATVs, original Maverick 1000cc, Gen 1...

🔥 PICTURE IS JUST A GENERIC REPRESENTATION OF A COMPLETE KIT. YOU WILL RECEIVE THE CORRECT KIT BASED ON THE MODEL INFO YOU LEAVE. 🔥   This kit is to fit the following, all 800cc CANAM ATVS/SXS (Gen 1 OR 2) PAY ATTENTION TO...

Maverick N/A Piston/Jug Rebuild Kit top end rebuild kit is the perfect solution to those needing to rebuild the top end on a 1000cc Mavericks or 1000R atvs. All kits include jugs, pistons, rings, clips, wrist pins, and all the gaskets needed. Our kits...

Important: This adapter installs in the stock oil-filter location only. It is not a relocation kit.Upgrade the factory Can-Am filter setup to a common automotive-style spin-on oil filter that can be sourced from most auto-parts stores.FitmentDesigned for Can-Am V-twin applications using the standard Can-Am-style...

WILL COME WITH VALVE COVER BOLTS. *THESE FIT ALL CANAM VTWIN ENGINES EXCEPT NEW GEN 3 ATVS, AGAIN ALL* GASKETS SOLD SEPERATE. THIS IS A SET TO DO ONE ENGINE. NO CRUSH WASHER REQUIRED! NO NEED TO MESSAGE AND ASK JUST TIGHTEN THEM DOWN. ...

Cast-aluminum clutch backplate for the Can-Am Maverick X3. Stronger than the stock backplate and can be drilled, tapped, or welded. Uses the stock outer cover.Aftermarket clutch note: Some aftermarket clutch combinations may require minor clearancing so the clutch sheave does not contact the housing.Select...

Designed for use with 3 bolt canam cams.

Fits ALL canam vtwin rotax engines.  SOLD AS A SET! (2)

1) Kit replaces all stock rubber motor mounts. 2) Stops drive shaft wear due to motor twisting 3) A must for all high horse power motors. 4) Fits 500/650/800/1000cc. Will be black or finished aluminum color. ALL CANAM VTWINS 

Will fit all rotax vtwins ATV and sxs. These are the gasket only that fit into the bottom of the water necks and will fit plastic or aluminum necks. Sold as a set (2) which is required for 1 engine. Part #18 in pics.

Make sure your airbox is leak proof with the legendary OMC airbox gaskets. Fits all canam Atvs 2013-24.. 

These are stock size main bearings for the case.  Includes 4 halves.. Fits all G1 and G2 rotax vtwins. 

This kit comes with both thru shaft seals and the pto cover seal.

Comes with the case gasket, mag gasket and the pto gasket.

Flywheel Puller 500/650/800/1000cc

These will fit all canam vtwins and x3s, defender mav sport and trail. These also DO have the pressure relief in the end to allow oil to keep flowing if the filter paper were to clog. 

These replace the stock plastic tensioners. Comes in a set of 2 with o rings.